Printbed
The temperature range of the printhead is 4 °C to 65 °C
Thu, 26 Sep, 2019 at 6:08 PM
The printbed can fit standard well plates, petri dishes, glass slides, and custom print surfaces.
Thu, 26 Sep, 2019 at 6:08 PM
For printing surfaces smaller than the area of the printbed it is recommended to use the claps to secure the surface. For unique print surfaces if the use o...
Thu, 26 Sep, 2019 at 6:09 PM
The printbed should reach the set temperature in approximately 10 minutes. It is recommended to allow the printhead to reach the set temperature prior to pl...
Thu, 26 Sep, 2019 at 6:11 PM
WARNING. Do NOT leave BIO X unsupervised while it runs ABL. Be prepared to unplug BIO X if ABL fails. Leaving BIO X unsupervised during the ABL process ris...
Mon, 11 May, 2020 at 2:15 AM
If you are using a 96 well plate on your BIO X's printbed and you are having a difficulty removing or lifting the well plate up with the lid, please fo...
Fri, 20 Nov, 2020 at 3:32 AM