Electromagnetic droplet (EMD) printhead
EMD stands for electromagnetic droplet which is the mechanism by which the droplets are extruded from this printhead
Fri, 27 Sep, 2019 at 2:55 PM
The printhead can heat up and maintain temperatures between 30 and 65 C
Fri, 27 Sep, 2019 at 2:55 PM
Yes, this printhead can rapidly deposit spheroids into well plates.
Fri, 27 Sep, 2019 at 2:56 PM
The fastest cycle time of the printhead is 1ms, so theoretically 1000 droplets a second. In practice, this maximum rate is dependent on the bioink utilized.
Fri, 27 Sep, 2019 at 2:57 PM
The open time is how long the valve is open to allow extrusion of a pressurized droplet. The cycle time is how frequency the valve is opened.
Fri, 27 Sep, 2019 at 2:57 PM
Yes, the printhead utilizes pneumatic pressure to dispense a droplet, making it compatible with cells.
Fri, 27 Sep, 2019 at 3:03 PM
The printhead can take a 3ml cartridge.
Fri, 27 Sep, 2019 at 3:08 PM
The printhead compresses the bioink within a cartridge. This cartridge is connected to an electromagnetic valve that can open and close for a set length of ...
Fri, 27 Sep, 2019 at 4:15 PM
For BIO X's Electromagnetic Droplet (EMD) user manual, please feel free to refer to the attached user manual below for your reference. For further assi...
Thu, 21 May, 2020 at 2:46 AM