General
The pressure range is between 200-700 kPa. The internal air compressor of the BIO X can provide a maximum pressure of 200 kPa. An additional 500 kPa can be ...
Mon, 6 Apr, 2020 at 5:06 PM
The build area of the BIO X is 128 mm in the X-axis by 85.1 mm in the Y-axis by ~40-80 mm in the Z-axis, depending on the printhead used. See figure below f...
Mon, 6 Apr, 2020 at 5:10 PM
The BIO X prints in the X-Y plane with layers stacked in the Z-direction. To optimize performance and resolution, the BIOX does not print in all three dimen...
Tue, 17 Sep, 2019 at 2:18 PM
BIO X is designed to operate between 20 and 23° Celsius, and its performance has been demonstrated at temperatures as low as -20°. Due to heat generate...
Mon, 6 Apr, 2020 at 5:16 PM
Yes, the BIO X can use G-code files. You can find guides to writing G-code here.
Mon, 6 Apr, 2020 at 5:18 PM
Preflow and postflow delay are two parameters used in pneumatically driven bioprinting. When bioprinting viscous gels, there is a delay between the initial ...
Mon, 6 Apr, 2020 at 5:25 PM
*Note packing content/quantity subject to change based on your order. Box one contents: Blue cartridge adapters with transparent blue tubing (...
Mon, 6 Apr, 2020 at 5:31 PM
Before starting off coding your G Code files, please feel free to visit this link below for further information: G-Code guide: https://cellink.fr...
Mon, 23 Mar, 2020 at 5:09 PM
Installing a HeartOS update and an error shows up? Sometimes and improperly ejected flash drive or an incorrect file location can cause errors when tryi...
Mon, 6 Apr, 2020 at 5:35 PM
In our newest HeartOS version we have relocated the surface probe calibration settings, which are now found in utilities menu and not within the print calib...
Tue, 25 Sep, 2018 at 4:53 PM