Bioprinting Assistant Software
If you'd like to control your bioprinter with your computer, you've come to the right place!
F20 is the slowest the Inkredible/Inkredible+ Motors will move. F is in units of mm/min. Any value of F lower than that would be printed at speed F20. ...
Fri, 2 Nov, 2018 at 5:01 PM
IF YOU HAVE PREVIOUSLY Installed a version of the HEARTWARE SOFTWARE PERFORM THE FOLLOWING STEPS FIRST: UNINSTALL HEARTWARE Navigate to the Location...
Wed, 21 Apr, 2021 at 4:48 PM
Please check the port you are connected to under the printer settings on HeartWare matches the port which the printer is currently connected to the PC under...
Tue, 31 Mar, 2020 at 3:32 PM
Installing the driver Some computers cannot connect to the bioprinters without the required driver. To enable the connection, follow the instruction...
Fri, 8 Dec, 2017 at 4:33 PM
In order to generate .gcode files that are compatible with the Inkredible/Inkredible+ printers the slic3r generated gcode files needs to passed through a po...
Thu, 14 Dec, 2017 at 11:30 AM
Overview: The Repeteir-Host Software allows Mac users to control theirBioprinters from their computers. NOTE: Using the Repeteir-Host soft...
Wed, 5 Jun, 2019 at 10:23 AM
If HeartWare is crashing after trying to connect to the bioprinter, please make sure there are no SD cards inserted to the Inkredible(+) and that the SD pri...
Tue, 31 Mar, 2020 at 3:26 PM
If your Inkredible(+) is not responsive to commands such as Home Axis or Calibrate Z (under Manual Control) from Heartware, as seen below. If t...
Tue, 31 Mar, 2020 at 3:30 PM
If you want to calibrate the Z axis using manual control of HeartWare, and instead of going up it is going down (and vice versa). You can do the following i...
Tue, 31 Mar, 2020 at 3:36 PM